Automotive industry
From scanning to workshop drawings in one week, in an area with an extremely high density of services.
- Floor area300 m²
- ServiceSupport for engineering firms
- SectorAutomotive
What was done
New pumping units had to be installed in an area with a very high density of services, respecting every route for people and machines. The deliverable was the drawings to fabricate the installation in the workshop and assemble it in the factory with the fit already checked.
A3D scanned the area in 3D to start from real measurements and modelled the structure, the existing services and the equipment in BIM. The new units were laid out on that model.
The scanning took one day and the drawings were delivered the following week. With the installation pre-assembled in the workshop, the intervention time in the plant is kept to the minimum.
Project images
-
The data capture, over the real hall. -
The pumping units, system by system. -
The layout, in detail. -
Plan of the area, network by network. -
Axonometric view of the networks. -
Layout drawing, produced from the model. -
From the real hall to the model, and from the model to the new installation. -
The units, assembled in the room. -
The room, with the pipework resolved.
Does your plant look like this one?
This is what a first area looks like: 300 m² measured in a day and workshop drawings the following week. It is bounded and priced in a 15-minute call, from ~€6,000 (estimated) per area.